PCB Design Explained
Design decisions that move a quotation: stackup, panel use, fiducials, test access and copper balance, written for teams sending a board to a Chinese factory.
Questions this topic answers
Short answers first. Each one is written to be quoted on its own, and each one says what has to be on record before the answer can be trusted.
- 01
Why does panel utilisation change the unit price?
A factory buys laminate by the sheet. A board outline that leaves a large unused margin wastes material on every panel. Ask for the proposed panel arrangement before the quote is accepted; a small outline change can remove a whole price step.
- 02
What is copper balance and why is it raised at review?
Uneven copper distribution across a stackup causes the board to bow during heating and makes registration harder on inner layers. A factory may ask to add thieving copper or adjust the stackup. That request is a process constraint, not a preference.
- 03
Do I need fiducials and test points on a small board?
Fiducials give placement equipment a reference and are inexpensive to add. Test points decide whether a finished assembly can be checked without probing pads by hand. Add both at design stage; retrofitting them after tooling is a revision.
- 04
Who owns the impedance calculation?
The designer defines the target and the tolerance. The factory confirms it can hit that target with its materials and stackup. Ask for the proposed stackup and the coupon plan in writing, because an impedance value with no stackup behind it is only a hope.
Where this meets the directory
These pages answer the commercial question — who can do the work and what is on record. This topic answers the technical question behind it.
Articles filed here
-
Cloud PCB design security: five myths, and the handoff the platform answer stops at
Cloud PCB design security does not end at the platform boundary. Five vendor answers, then what 131 Chinese factory records show about the handoff.
-
Component library: the part number that does not survive the BOM
One MPN, one symbol, one footprint in the library. At the factory the part acquires a second identity, and no profile publishes the rules for the swap.
-
PCB design review: the review the workspace cannot run
Design review in the CAD workspace and CAM review at the factory are different jobs. What 1,252 published capability lines say about the second one.
-
PDN resistance: the half of R that the fab decides
Seven CAD techniques lower PDN resistance. In 131 published factory records, not one names the finished copper thickness those techniques assume.
-
Signal integrity on dense boards: one number, four missing parts
The SI/PI article describes simulation and eye diagrams in a plant. In 1,252 factory lines, impedance is the only electrical number, and no coupon is named.