Blog topic · 13 / 16

PCB Testing Explained

Bare-board and assembly test questions: flying probe, ICT, AOI, X-ray and boundary scan, and which report should come back with a production lot.

A test method answers one kind of question. Flying probe checks a bare board, ICT checks a populated net, AOI checks appearance and X-ray checks joints you cannot see. Naming only one leaves gaps.

Questions this topic answers

Short answers first. Each one is written to be quoted on its own, and each one says what has to be on record before the answer can be trusted.

  1. 01

    Do I need both bare-board and assembly test?

    They catch different faults. A bare board can pass electrical test and still assemble badly, and a populated board can fail because of a defect that was already in the laminate. Define each stage separately in the RFQ instead of asking for testing in general.

  2. 02

    When is X-ray necessary rather than AOI?

    When the joint is hidden, as with BGA, QFN and via-in-pad work. AOI sees surface features and cannot see voids under a package. Ask which percentage of joints is inspected and whether the criterion is taken from your acceptance document or the factory default.

  3. 03

    What should a test report tie back to?

    Your lot number, the board revision, the test program version and the pass or fail count. A report without those four fields cannot be connected to a shipment if a failure appears later. Ask for the same fields on a retest.

  4. 04

    Is a coverage figure on a website useful?

    Only if it states what is covered. A high figure that skips power nets or analogue sections tells you little about your board. Ask for the net list coverage against your design rather than the factory average.

Where this meets the directory

These pages answer the commercial question — who can do the work and what is on record. This topic answers the technical question behind it.

Articles filed here

  1. Signal integrity on dense boards: one number, four missing parts

    The SI/PI article describes simulation and eye diagrams in a plant. In 1,252 factory lines, impedance is the only electrical number, and no coupon is named.

  2. Hardware version control: the half that lives at the supplier

    Your repository controls the design; the purchase order controls the board. How a revision travels through CAM, tooling and test, and where it gets lost.

  3. When to switch from PCBWay or JLCPCB to a direct Chinese PCB factory

    Five signals that a prototype should leave an online PCB platform: pooled-panel pricing, complex stackups, audit needs, mixed SMT, and direct CAM access.