PCB Surface Finishes Explained
Surface finish questions answered by assembly needs and shelf life: HASL, ENIG, ENEPIG, OSP and immersion finishes, and what a finish claim must state.
Questions this topic answers
Short answers first. Each one is written to be quoted on its own, and each one says what has to be on record before the answer can be trusted.
- 01
Which finish should I specify for fine-pitch components?
Flatness matters most at fine pitch. Ask the factory which finishes it can hold within the coplanarity your package needs, and ask for the measured range rather than a capability statement. A finish that is flat on a coupon may not be flat across your panel.
- 02
How does shelf life affect the choice?
Some finishes degrade after one reflow cycle or after months in storage, while others tolerate several heat exposures. State how long boards will be stored and how many thermal cycles they will see. A finish that is cheap at purchase can be expensive if the lot expires before assembly.
- 03
What does a finish record need to contain?
The finish name, the thickness range, the process site and the lot it was applied to. A line in a capability table proves the shop offers the finish, not that your boards received it or that the thickness was measured.
- 04
Can I change finish between prototype and production?
Yes, but it can change solder joint behaviour and impedance at the pad. Treat it as a design change, run a small build with the production finish and record the result before the full order. Do not assume the prototype result carries over.
Where this meets the directory
These pages answer the commercial question — who can do the work and what is on record. This topic answers the technical question behind it.
Articles filed here
The four questions above are the standing brief for this topic. Dated field notes are published at the blog index as each one is finished.